Connecting Rods, Checking Radial Clearance: Procedure

NOTE:

Use Old Bolts To Measure Radial Play.

-- Remove the connecting rod bearing cap.

-- Clean the bearing cap and journal.

-- Place the Plastigauge^® over the entire width of the bearing journal or into the bearing shells.

-- Install and tighten the connecting rod bearing cap -item ) OVERVIEW - PISTON AND CONNECTING ROD. Do not turn the crankshaft while doing this.

-- Install the connecting rod bearing cap.

-- Compare width of Plastigauge^® with calibrated scale.

Radial Clearance:

-- Replace bolts for the final assembly.