Sub-Assembly Bracket, Version 2 - Tightening Specifications And Sequence

• Replace the bolts that were tightened with an additional turn after removing them.

• Mount the sub-assembly bracket and then install the bolts -4- first.
• Tighten the bolts in the steps shown in the sequence:

Fig 1: Accessory Assembly Bracket Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

Step	Bolts	Tightening Specification/Additional Turn
1.	-1 through 5-	Install by hand all the way
2.	-1 through 5-	20 Nm
3.	-1 through 5-	90° additional turn