Sub-Assembly Bracket, Version 1 - Tightening Specifications And Sequence
- Replace the bolts that were tightened with an additional turn after removing them.
-- Mount the accessory assembly bracket and then mount the bolts -4-.
-- Tighten Bolts In Three Stages In -1 Through 5- Sequence As Follows:
Tighten The Bolts In The Steps Shown In The Sequence:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 through 5- | Install by hand all the way |
| 2. | -1 through 5- | 20 Nm |
| 3. | -1 through 5- | 90° additional turn |