Auxiliary Components Bracket, Removing And Installing: Removing

-- Disconnect the connectors:

Courtesy of AUDI OF AMERICA, LLC

2 - For Reduced Oil Pressure Switch -F378- -1-

4 - For Oil Pressure Switch -F22- -3-

-- Remove the ribbed belt from the generator. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Remove the generator.

-- Remove the bolts -1 and 2- and move the front coolant pipes to the side.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -arrows-.

-- Disconnect the connector -1- on the A/C Compressor Regulator Valve -N280-.

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Refrigerant Can Cause Serious Personal Injury.

-- Remove A/C compressor bolts -arrows-.

CAUTION:

There Is A Risk Of Damaging The Condenser, The A/C Compressor And The Refrigerant Lines And Hoses.

-- Remove the A/C compressor with the refrigerant lines connected and tie it up on the right side.

-- Remove the oil filter.

-- Remove the bolts -arrow- from the oil dipstick tube.

Courtesy of AUDI OF AMERICA, LLC

-- Place the :VAS6208 under engine.

-- Remove the bolts -1 through 5- and pull off the accessory assembly bracket from the coolant pump housing.

Courtesy of AUDI OF AMERICA, LLC