Sensor Wheel, Removing And Installing: Notes

CAUTION:

This Procedure Contains Mandatory Replaceable Parts. Refer To Component Overview Prior To Starting Procedure.

Mandatory Replacement Parts

Bolts - Sensor Wheel

-- Remove engine.

-- Remove the transmission-side sealing flange. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .

-- Remove the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

-- Remove the balance shaft drive chain. Refer to BALANCE SHAFT DRIVE CHAIN, REMOVING AND INSTALLING .

-- Remove the connecting rod bearing cover.

-- Remove the crankshaft bearing cover.

-- Remove the crankshaft and the sensor wheel.

-- Always replace sensor wheel -2- whenever bolts are removed -1-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

After Tightening A Second Time, The Attachment Point Of The Countersunk Screws Of The Sensor Wheel Are So Deformed That The Screw Heads Lie On The Crankshaft -3- -Arrows- And The Sensor Wheel Is Loose Underneath The Screws.

Installation Of Sensor Wheel Is Only Possible In One Position - The Bores Are Offset.

-- The combustion misfire adaptations must be adjusted after replacing the transmission. Select 01 - Reset Combustion Misfire Adaptation in Guided Fault Finding on the Vehicle Diagnostic Tester.