Overview - Balance Shaft
- Bolt
- 9 Nm
- Always replace
- Balance Shaft
- Intake side
- Must be replaced after removing
- Lubricate the bearing with engine oil
- Replacing. Refer to BALANCE SHAFT, REMOVING AND INSTALLING, INTAKE SIDE .
- Balance Shaft
- Exhaust side
- Must be replaced after removing
- Lubricate the bearing with engine oil
- Replacing. Refer to BALANCE SHAFT, REMOVING AND INSTALLING, EXHAUST SIDE .
- Bolt
- 9 Nm
- Always replace
- Pipe for the Balance Shaft
- Installed position. Refer to the illustration below
- Coolant Pump Drive Sealing Ring
- Replacing. Refer to BALANCE SHAFT SEALING RING, REPLACING, INTAKE SIDE .
- The pin from the balance shaft pipe must fit into the groove -arrow-