Overview - Rear Lid, Stop And Adjusting Buffer

Fig 1: Components Location Rear Lid, Stop and Adjusting Buffer

Courtesy of AUDI OF AMERICA, LLC

Lower Stop Buffer
- 1.5 Nm
Upper Stop Buffer
-- To remove push the clamping pin and remove the stop buffer.

-- Remove the clamping pin from the side panel.

-- Install the stop buffer with an expanding clip and push the clamping pin in flush.
Side Panel
Upper Adjusting Buffer
- Removing and installing. Refer to ADJUSTING BUFFER, REMOVING AND INSTALLING
Rear Lid
Lower Adjusting Buffer
- Removing and installing. Refer to ADJUSTING BUFFER, REMOVING AND INSTALLING
Side Panel