Fog Lamp, Adjusting

Checking and Adjusting Conditions 

• Tire pressure is OK.
• The headlamp lens must be clean and dry.
• The headlamp lens may not be damaged.
• Headlamp-reflector and lamp are OK.
• Roll the vehicle several yards or move it back and forth several times to seat the springs.
• The parking brake must not be engaged so that the vehicle is not under stress.
• The vehicle and headlamp adjusting unit must be on a level surface.
• The headlamp adjusting unit must be aligned to the vehicle. Refer to the Headlamp Adjusting Unit Instructions.
• The inclination dimension is set on the headlamp adjusting unit. Refer to the Headlamp Adjusting Unit Operating Instructions.
• Vehicle load must be created.

Vehicle load on driver's seat in otherwise unloaded vehicle (curb weight).

• One person or 75 kg.

Procedure 

-- The vehicle must be standing on a flat surface.

-- Turn the headlamp switch to "low beam" - not "Auto".

-- Pull the headlamp switch to "fog lamp".

-- During the program, you will be asked to perform a headlamp adjustment.

Headlamp Adjustment 

-- To adjust headlamp range, turn the adjusting screw -arrow-.

• Angle dimension: 2%