Initialization [08/2013 - ]

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

INITIALIZE PARKING ASSIST MONITOR SYSTEM
1. When "System initializing" is displayed on the multi-media module display, correct the steering angle neutral point using the following method.
  1. Fully turn the steering wheel to the right and left on flat ground.
    NOTE:
    Memorizing the steering angle neutral point must be carried out with the power switch on (READY). Apply the parking brake, depress the brake pedal, check that the shift lever is in P, and ensure that the vehicle is not moving.
    
    HINT:
    - The "?" button is displayed at the same time as "System initializing". If the "?" button is selected, this method is displayed.
    - If the steering angle neutral point cannot be memorized by fully turning the steering wheel to the right and left, perform Steering Angle Setting in Calibration. Refer to CALIBRATION [08/2013 - ] .