Right Cylinder Head

WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the front coolant pipe. Refer to FRONT COOLANT PIPE, REMOVING AND INSTALLING .

-- Loosen hose clamp -1- and lift the clamp -2- to remove the coolant hoses.

NOTE:

Ignore the -arrows-.

-- Remove the union nut -right arrow- and then remove the high pressure line -1-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -left arrow-.

-- Remove the banjo bolt -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the guide pins for the glide track -1- and for the tensioning rail -2-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore :T40246 .

Continued for Both Sides

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts and the cylinder head carefully.

CAUTION:

Danger of damaging the glow plugs when removing the cylinder head.

Do not lay the removed cylinder head on the sealing surface with the glow plugs installed otherwise the glow plugs will protrude slightly past the sealing surface