Removal And Installation

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: All seatbelt components must be inspected and corrected as part of any collision repair. Inspect all seatbelt components as prescribed by Safety Belt Inspection and Repair After a Collision . Failure to follow this instruction may result in incorrect operation of the seatbelt system and increase the risk of serious personal injury or death in a crash.

1.

Position the seat upright.

2.

Remove the nut and safety belt buckle from underneath the seat.
- To install, tighten to 55 Nm (41 lb-ft).

3.

NOTE: When installing the safety belt buckle, make sure to engage the anti-rotation tab to the seat frame.

To install, reverse the removal procedure.

4.

Check the active restraint system for correct operation. For additional information, refer to the appropriate Functional Test in Component Test .