LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> A6 Premium >> Repair and Diagnosis >> External Pages >> Different car >> Section 196 (Safety Connect System (Diagnostic Codes & Symptom Tests)) >> Safety Connect System >> Symptom Tests >> Green And Red Indicators Blink Simultaneously [08/2013 - ] >> Procedure

Green And Red Indicators Blink Simultaneously [08/2013 - ]: Procedure

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHANGE SUBSCRIPTION MODE 
    1. Turn the power switch on (IG).
    2. Push the manual (SOS) switch.
    3. The vehicle will issue a voice prompt: "Safety Connect is not initialized. To activate, please press the button again within 5 seconds."
    4. Push the manual (SOS) switch and a beep will be emitted.
    5. Telematics service provider will send an End Call command and the manual (SOS) switch green indicator will illuminate.
    6. A voice prompt will state: "Activation Complete" (This may take up to 3 minutes)
    7. Turn the power switch off.

    NEXT: Go to next step 

  2. CHECK SUBSCRIPTION MODE 
    1. Turn the power switch on (IG).
    2. Confirm the manual (SOS) switch red indicator illuminates for 2 seconds and turns off and the manual (SOS) switch green indicator illuminates and remains on. Refer to SYSTEM DESCRIPTION [08/2013 - ] .

    NEXT → END 

scientia non olet · About LEMON Manuals