DTC B15CC: Backup Battery Failure [08/2013 - ]: Procedure

1. Turn the power switch off.
2. Connect the Techstream to the DLC3.
3. Turn the power switch on (IG) and wait for 10 seconds.
4. Turn the Techstream on.
5. Perform "Health Check" and check for current DTCs. Refer to HEALTH CHECK [08/2013 - ] .

   Result

   Result	Proceed to
   DTC B15CC is output.	A
   DTC B15CC is not output.	B

B → See step   8 

A: Go to next step 

1. Disconnect the H101 DCM (Telematics Transceiver) connector.
2. Disconnect the H103 BUB (Back-Up Battery) connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   H101-30 (BBI+) - H103-1 (BBO+)	Always	Below 1 Ω
   H101-13 (BBI-) - H103-5 (BBO-)	Always	Below 1 Ω
   H101-20 (CTR1) - H103-3 (BTR1)	Always	Below 1 Ω
   H101-21 (CTR2) - H103-4 (BTR2)	Always	Below 1 Ω
   H101-30 (BBI+) - Body ground	Always	10 kΩ or higher
   H101-13 (BBI-) - Body ground	Always	10 kΩ or higher
   H101-20 (CTR1) - Body ground	Always	10 kΩ or higher
   H101-21 (CTR2) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Replace the BUB (Back-Up Battery) with a normal one and check if the same problem occurs again. Refer to REMOVAL [08/2013 - ] .
   NOTE:

   The BUB (Back-Up Battery) must not be replaced while an ACN call is in progress. Refer to ACN CALL END [08/2013 - ] .

NEXT: Go to next step 

1. Clear the DTC. Refer to DTC CHECK / CLEAR [08/2013 - ] .

NEXT: Go to next step 

1. Recheck for DTCs and check if the same trouble occurs again. Refer to HEALTH CHECK [08/2013 - ] .

   OK

   No DTC is output.

NG → See step   6 

OK → END 

1. Replace the DCM (Telematics Transceiver). Refer to REMOVAL [08/2013 - ] .
   NOTE:

   • The power switch must be off.
   • Do not replace the DCM (telematics transceiver) with one from another vehicle.

NEXT: Go to next step 

1. Perform "PRL UPDATE". Refer to PRL UPDATE [08/2013 - ] .

NEXT → See step   9