DTC B1583: GPS Signal Unreceived [08/2013 - ]: Procedure

1. Check that there are no problems with the telephone and GPS antenna assembly.

   OK

   The antenna is not excessively dirty, and there are no objects blocking signal reception.

NG → REMOVE FOREIGN MATTER 

OK: Go to next step 

1. Replace the telephone and GPS antenna assembly. Refer to REMOVAL [08/2013 - ] .

NEXT: Go to next step 

1. Clear the current and historic DTCs. Refer to DTC CHECK / CLEAR [08/2013 - ] .

NEXT: Go to next step 

1. Drive the vehicle for at least 15 miles, manual (SOS) switch red indicator will illuminate at approximately 10 miles if problem still exists.
2. Turn the power switch off.
3. Connect the Techstream to the DLC3.
4. Turn the power switch on (IG) and wait for 10 seconds.
5. Turn the Techstream on.
6. Perform "Health Check" and check current and historic DTC. Refer to HEALTH CHECK [08/2013 - ] .

   HINT: 

   Basically turning power switch off will clear the current DTC until vehicle is driven about 10 miles again with the issue.

   Result

   Result	Proceed to
   DTC B1583 is output.	A
   DTC B1583 is not output.	B

B → END 

A: Go to next step 

1. Replace the DCM (Telematics Transceiver). Refer to REMOVAL [08/2013 - ] .
   NOTE:

   • The power switch must be off.
   • Do not replace the DCM (telematics transceiver) with one from another vehicle.

NEXT: Go to next step 

1. Perform "PRL UPDATE". Refer to PRL UPDATE [08/2013 - ] .

NEXT → See step   7