DTC C1AC2: Slave Module Horizontal Axis Misalignment [08/2013 - ]: Procedure
WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK INSTALLATION CONDITION
- Check the installation condition of the blind spot monitor sensor RH. Refer to OPERATION CHECK [08/2013 - ]
.
HINT:
Take the appropriate action in accordance with the result.
NEXT: Go to next step
- Check the installation condition of the blind spot monitor sensor RH. Refer to OPERATION CHECK [08/2013 - ]
.
- PERFORM BEAM AXIS CONFIRMATION
- Install the rear bumper. Refer to INSTALLATION [08/2013 - ] .
- Perform Blind Spot Monitor Beam Axis Confirmation using the Techstream. Refer to OPERATION CHECK [08/2013 - ] .
NG → See step 3
OK → END
- REPLACE BLIND SPOT MONITOR SENSOR RH. Refer to REMOVAL [08/2013 - ]