DTC C1ABB: Blind Spot Monitor Master Module Beam Axis Inspection Incomplete [08/2013 - ]: Procedure

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

PROCEED TO TEST MODE (BLIND SPOT MONITOR BEAM AXIS INSPECTION)
1. Change the blind spot monitor sensor LH to Test Mode using the Techstream.
  HINT:
  
  Refer to Blind Spot Monitor Beam Axis Inspection. Refer to OPERATION CHECK [08/2013 - ] .
NEXT → END