Guide Lines are Displayed with Vehicle Center Line [08/2013 - ]: Procedure

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

CHECK SCREEN MODE

Check the back guide monitor screen.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Result

Result	Proceed to
Guide lines are displayed with vehicle center line.	A
Guide lines are displayed without vehicle center line.	B

TEXT IN ILLUSTRATION

*a	Vehicle Center Line

B → See step 4

A: Go to next step

CHECK HARNESS AND CONNECTOR (REAR TELEVISION CAMERA ASSEMBLY - BODY GROUND)

Disconnect the U6 rear television camera assembly connector.

Measure the resistance according to the value(s) in the table below.

Standard Resistance

Tester Connection	Condition	Specified Condition
U6-1 (CURT) - Body ground	Always	Below 1 Ω

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR

OK → See step 3

REPLACE REAR TELEVISION CAMERA ASSEMBLY. Refer to REMOVAL [08/2013 - ]
USE SIMULATION METHOD TO CHECK (A WIRE MAY BE OPEN). Refer to ELECTRONIC CIRCUIT INSPECTION PROCEDURE [08/2013 - ]