LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> A6 Premium >> Repair and Diagnosis >> External Pages >> Different car >> Section 185 (Lighting System (Interior) (Service Information)) >> AMBIENT LIGHT (for Front Door) >> Inspection [08/2013 - ] >> Inspection [08/2013 - ]

Inspection [08/2013 - ]

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (AMBIENT LIGHT) 
    1. Connect a positive (+) lead from the auxiliary battery to terminal 1 (+) and a negative (-) lead to terminal 2 (-).
      Fig 1: Identifying Ambient Light LH Connector End View
      GTY401743Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Check that the ambient light comes on.

      OK

      Ambient light comes on.

      TEXT IN ILLUSTRATION

      *a Component without harness connected
      (Front Door Trim Board Sub-assembly LH)

      If the result is not as specified, replace the front door trim board sub-assembly LH.

  2. INSPECT FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH (AMBIENT LIGHT) 
    1. Connect a positive (+) lead from the auxiliary battery to terminal 1 (+) and a negative (-) lead to terminal 2 (-).
      Fig 2: Identifying Ambient Light RH Connector End View
      GTY401743Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Check that the ambient light comes on.

      OK

      Ambient light comes on.

      TEXT IN ILLUSTRATION

      *a Component without harness connected
      (Front Door Trim Board Sub-assembly RH)

      If the result is not as specified, replace the front door trim board sub-assembly RH.

scientia non olet · About LEMON Manuals