LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> A6 Premium >> Repair and Diagnosis >> External Pages >> Different car >> Section 168 (Tire Pressure Monitoring System (Diagnostic Codes & Circuit Tests)) >> Tire Pressure Warning System >> DTC C2126/26: Transmitter ID not Received in Main Mode [08/2013 - ] >> Description

DTC C2126/26: Transmitter ID not Received in Main Mode [08/2013 - ]: Description

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

After all transmitter IDs are registered, DTC C2126/26 is stored in the tire pressure warning ECU and receiver and the tire pressure warning light blinks for 1 minute and then illuminates.

When the tire pressure warning ECU and receiver successfully receives radio waves from all the transmitters whose IDs are stored in the ECU, DTC C2126/26 is cleared and the tire pressure warning light goes off.

DTC No. DTC Detection Condition Trouble Area
C2126/26 After transmitter ID registration is completed, ECU does not receive radio waves from transmitters whose IDs are stored in ECU.
  • Transmitter ID registration failure
  • Tire pressure warning valve and transmitter
  • Tire pressure warning ECU and receiver

HINT: 

The purpose of this DTC is to help prevent delivering a vehicle that has incorrectly registered transmitter IDs. After all IDs are registered, DTC C2126/26 is detected and the tire pressure warning light blinks for 1 minute and then illuminates. If the tire pressure warning light does not go off after a little while, the transmitter IDs may be incorrectly registered.