Cruise SET Indicator Light Circuit [08/2013 - ]: Procedure
WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
- PERFORM ACTIVE TEST USING TECHSTREAM (INDICAT. LAMP SET)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body / Combination Meter / Active Test.
- Check the cruise control SET indicator light by performing the Active Test.COMBINATION METER
Tester Display Test Part Control Range Diagnostic Note Indicat. Lamp SET Cruise control SET indicator light Cruise control SET indicator light ON / OFF - OK
The cruise control SET indicator light goes on or off.
- Turn the power switch off.
NG → See step 3
OK → See step 2
- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [08/2013 - ]
- REPLACE COMBINATION METER ASSEMBLY. Refer to REMOVAL [08/2013 - ]