On-Vehicle Inspection [08/2013 - ]

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

CHECK THROTTLE WITH MOTOR BODY ASSEMBLY
1. Put the engine in inspection mode (maintenance mode). Refer to INSPECTION MODE PROCEDURE [08/2013 - ] .
2. Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range with the A/C switch off
  Standard
  
  950 to 1050 rpm
  NOTE:
  - Be sure to perform this step with all accessories off.
  - Make sure that the shift lever is in P.
3. Perform a road test and confirm that there are no abnormalities.