Flywheel, Removing And Installing: Installing
Install In Reverse Order Of Removal. At The Same Time Note The Following:
-- Always clean the transmission housing in the area where the differential is accessed -arrow A- and the shaft seal -arrow B-.
Replace The Shaft Seal Between The Differential And Transmission Housing -arrow B- If It Is Damaged.
-- Fill the space between the sealing/dust lip halfway with sealing grease. Refer to the parts information for the correct sealing grease.
-- Clean the input shaft -arrow-.
-- Lubricate the input shaft splines using Grease for Clutch Disc Shaft Splines :G 000 100 .
-- Slide the clutch module onto the input shaft -arrow- carefully without tilting it.
-- Remove the :T40176 from the flywheel -A-.
-- Install the left flange shaft. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .