Test Sequence

• Engine oil temperature at least 30 °C (86 °F).
• Battery voltage at least 12.7 V.

Required preliminary work. Refer to COMPRESSION, CHECKING [For transmission(s) 0B5, 0CK] .

-- Remove the ignition coils with power output stages. Refer to IGNITION COILS WITH POWER OUTPUT STAGES, REMOVING AND INSTALLING .

-- Disconnect the connectors:

Courtesy of AUDI OF AMERICA, LLC

1. For the FSI Fuel Injectors in the Cylinder Head
2. For MPI Fuel Injectors in the Intake Manifold, If Installed

-- Remove the spark plugs using the :3122B  .

Courtesy of AUDI OF AMERICA, LLC

-- Check the compression using :VAG1763  , :VAG1381/1  and :VAG1381/5A  . Information on using the tester. Refer to the Operating Instructions.

Courtesy of AUDI OF AMERICA, LLC

• The help of a second technician is necessary for the following step.

-- Have a second technician operate the starter until the tester stops displaying a pressure increase.