Overview - EVAP System, Except A6 Hybrid
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi A6 Quattro, 2017 Audi A6, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Breather Line
- To EVAP Canister Purge Regulator Valve 1 -N80-
- Connector coupling, separating and connecting. Refer to CONNECTOR COUPLINGS, SEPARATING .
- Clipped to the bracket
- Bolt
- 20 Nm
- O-ring
- Valve
- Breather Line
- From the fuel tank
- Connector coupling, separating and connecting. Refer to CONNECTOR COUPLINGS, SEPARATING .
- EVAP Canister
- Installed location: on the left side at the back of the underbody under the cover
- Removing and installing. Refer to EVAP CANISTER, REMOVING AND INSTALLING, EXCEPT AUDI A6 HYBRID .
- Bolt
- 20 Nm
- Vent Line
- Vents to the outside at the left rear under the wheel housing liner
- Connector coupling, separating and connecting. Refer to CONNECTOR COUPLINGS, SEPARATING .
- Bracket
- Bolt
- 20 Nm
- Bolt
- 20 Nm