Condenser, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Installation is done is reverse order, observe the following:

NOTE:

The removed condenser contains refrigerant oil that must be returned to the refrigerant circuit (with the new condenser). Refer to REFRIGERANT CIRCUIT COMPONENTS, REPLACING (Refrigerant R134a, Servicing; Refrigerant Circuit Components, Replacing).

-- Install the refrigerant lines on the condenser. Refer to REFRIGERANT LINES, DISCONNECTING AND CONNECTING AT CONDENSER .

-- Evacuate the refrigerant circuit and fill it. Refer to USING SERVICE STATION (Refrigerant R134a, Servicing; Refrigerant Circuit, Using Service Station).

-- Operate the A/C system after filling the refrigerant circuit. Refer to A/C SYSTEM, STARTING OPERATION AFTER FILLING REFRIGERANT CIRCUIT .

-- Install the remaining removed components.

-- Turn on the ignition.

-- Check the DTC memory and erase any displayed entries using the Vehicle Diagnostic Tester in the "Guided Fault Finding " function.