Left Flange Shaft, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2020 Audi S4, 2020 Audi A4, 2019 Audi S4, 2019 Audi A5 Quattro, and 2019 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

The transmission is installed.

-- Drain the transmission fluid. Refer to TRANSMISSION FLUID, DRAINING AND FILLING .

-- Remove the left drive axle. Refer to DRIVE AXLE .

-- Remove the left drive axle heat shield. Refer to DRIVE AXLE .

-- Remove the left shock absorber fork. Refer to SUSPENSION STRUT AND UPPER CONTROL ARM .

-- Remove the bolts -arrows- from the flange shaft mounting bracket.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the lower cover -arrow- from the transmission.

Courtesy of AUDI OF AMERICA, LLC

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Risk of damaging the seal between the final drive and the transmission housing when removing the flange shaft.

If the flange shaft -arrow- is not held in a central position, the seal on the flange shaft spline will be damaged.
A seal must be replaced if it is damaged.

-- To avoid damaging the seal, support and guide the flange shaft out of the opening in the transmission.

-- Remove the left flange shaft from the transmission in the direction of -arrow A-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore items -1 and 3- and -arrow B-.