LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> A4 Premium >> Repair and Diagnosis >> External Pages >> Different car >> Section 1496 (Final Drive, Differential (Servicing - 0CJ, 0CL, 0CK, 0DN, 0DP)) >> Final Drive, Differential >> Center Differential >> Center Differential, Removing And Installing >> Removing

Center Differential, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2020 Audi S4, 2020 Audi A4, 2019 Audi S4, 2019 Audi A5 Quattro, and 2019 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

General repair instructions. Refer to GENERAL REPAIR INFORMATION .

Guidelines for clean working conditions. Refer to RULES FOR CLEANLINESS WHEN WORKING ON DSG .

-- Remove the driveshaft. Refer to appropriate service information. .

-- Drain the transmission fluid. Refer to TRANSMISSION FLUID, DRAINING AND FILLING .

CAUTION:

Transmission components could be damaged.

  • The self-locking center differential is pretensioned with a pressure spring.
  • Carefully remove the center differential housing from the transmission toward the rear. Otherwise the center differential could fall out of the transmission.

-- Remove the bolts from the self-locking center differential housing in the following sequence: -11 to 1-.

GWWA39-10856Courtesy of AUDI OF AMERICA, LLC

-- Remove the oil guide piece.

GWWA39-10857Courtesy of AUDI OF AMERICA, LLC

-- Secure the center differential -1- so it does not fall out or remove it toward the rear from the input shaft.

GWWA39-10416Courtesy of AUDI OF AMERICA, LLC