Cylinder Head Cover - Tightening Specifications And Sequence
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2020 Audi S4, 2020 Audi A4, 2019 Audi S4, 2019 Audi A4, and 2018 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Replace the bolts that were tightened with an additional turn after removing them.
Pay attention that the cylinder head cover is not tilted.
-- Tighten the bolts in the steps shown in the sequence:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 to 6- | Install all the way in multiple steps by hand |
| 2. | -1 to 6- | 8 Nm |
| 3. | -1 to 6- | 90° additional turn |