Vibration Damper Seal, Replacing: Removing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2020 Audi S4, 2020 Audi A4, 2019 Audi S4, 2019 Audi A4, and 2018 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the vibration damper. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .

-- Remove the seal -arrow- with the :T40274 .

Fig 1: Identifying Seal Installer - Crankshaft T40274

GWWN13-10592

Courtesy of AUDI OF AMERICA, LLC

-- Clean the contact and sealing surface.

-- Push the seal -arrow- on the :T10354 .

Fig 2: Identifying Crankshaft Seal Installer T10354

GWWA13-11008

Courtesy of AUDI OF AMERICA, LLC

The closed side of the seal points to the :T10354 .

-- Push the seal -arrow- with the :T10354 on the :T10531/2 and place on the lower timing chain cover.

Fig 3: Identifying Crankshaft Seal Installer T10354 And Tensioning Pins T10531/2

GWWA13-11059

Courtesy of AUDI OF AMERICA, LLC

-- Additionally attach the :T10375 and tighten the :T10531/4 .

Fig 4: Driving Seal In Using Seal Installer - Crankshaft T10354

GWWA13-11060

Courtesy of AUDI OF AMERICA, LLC

-- Drive the seal in all the way using the :T10354 .