Overview - Balance Shaft Drive Chain: Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2020 Audi S4, 2020 Audi A4, 2019 Audi S4, 2019 Audi A4, and 2018 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
- Three Stage Chain Sprocket
- Installation position. Refer to Figure.
- Guide Pin
- 20 Nm
- Tensioning Rail
- For balance shaft drive chains
- Balance Shaft Drive Chain
- Removing and installing. Refer to BALANCE SHAFT DRIVE CHAIN, REMOVING AND INSTALLING .
- Guide Pin
- 20 Nm
- Exhaust Side Balance Shaft
- Overview. Refer to OVERVIEW - BALANCE SHAFT .
- Chain Tensioner
- 85 Nm
- Seal
- Always replace after removing.
- Cylinder Block
- Intake Side Balance Shaft
- Overview. Refer to OVERVIEW - BALANCE SHAFT .
- O-ring
- Lubricate with engine oil
- Mounting Pin
- Lubricate with engine oil
- Installation position. Refer to Figure.
- Intermediate Sprocket
- The intermediate sprocket must be replaced if the bolt -item ) OVERVIEW - BALANCE SHAFT DRIVE CHAIN - Bolt is loosened.
- Thrust Washer
- Bolt
- Tightening specifications and sequence. Refer to Figure.
- Always replace after removing.
- The intermediate sprocket -item ) OVERVIEW - BALANCE SHAFT DRIVE CHAIN - INTERMEDIATE SPROCKET must be replaced if the bolt is loosened.
- Guide Rail
- For balance shaft drive chains
- Guide Pin
- 20 Nm
- Guide Rail
- For the balance shaft timing chain
- Guide Pin
- 12 Nm