Intermediate Sprocket - Tightening Specifications And Sequence

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2020 Audi S4, 2020 Audi A4, 2019 Audi S4, 2019 Audi A4, and 2018 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Intermediate Shaft Sprocket

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Replace the bolts that were tightened with an additional turn after removing them.

-- Tighten The Bolt In Steps:

Step	Tightening Specification/Additional Turn
1.	10 Nm
2.	-- Turn the intermediate sprocket The intermediate sprocket must not have any play otherwise loosen and tighten it again.
3.	25 Nm
4.	90° additional turn