Bearing Bracket, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2020 Audi S4, 2020 Audi A4, 2019 Audi S4, 2019 Audi A4, and 2018 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
-- Install the screws -arrows- and tighten. Tightening specification -item ) OVERVIEW - CYLINDER HEAD - BOLT.
-- Coat the holes -arrows- with engine oil.
-- Check if the adapter sleeve -1- is installed.
WARNING:
Risk of damaging the bearing bracket.
- Carefully mount the bearing bracket without tilting it.
-- Attach the bearing mount and install the bolts -1 to 6- all the way by hand.
-- Remove the :T40267 .
-- Tighten the bearing bracket bolts. Refer to Figure.
Installation Is Performed In Reverse Order Of Removal, Noting The Following:
-- Install the upper timing chain cover. Refer to UPPER TIMING CHAIN COVER, REMOVING AND INSTALLING .
- Refer to Figure
- Refer to OVERVIEW - CAMSHAFT TIMING CHAINS
- Refer to OVERVIEW - CYLINDER HEAD