Balance Shaft Drive Chain, Removing And Installing: Installing

Install in reverse order of removal and note the following:

Requirements: 

• The crankshaft is at "TDC" ; the V-shaped cut-out on the three-layer chain sprocket points in an imaginary vertical line -arrows- centered between the camshaft chain sprockets.

  Courtesy of AUDI OF AMERICA, LLC

• Three-layer chain sprocket locked with the :T10531/2  .

-- Place the balance shaft drive chain next as shown on the balance shafts.

Courtesy of AUDI OF AMERICA, LLC

• The painted chain links must align with the markings -arrows- on the chain sprockets.

-- Insert the guide track -1- and tighten the guide pins -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Position the painted chain link -arrow- from the balance shaft drive chain at the marking on the three-layer chain sprocket as shown.

Courtesy of AUDI OF AMERICA, LLC

-- Insert the tensioning rail -2- and tighten the guide pin -1-.

-- Tighten the chain tensioner -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Check the position again:

Courtesy of AUDI OF AMERICA, LLC

• The painted chain links must align with the markings -arrows- on the chain sprockets.

-- Install the camshaft timing chain. Refer to CAMSHAFT TIMING CHAIN, REMOVING AND INSTALLING .