Transmission Fluid Auxiliary Hydraulic Pump -V552-, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2020 Audi A4, 2019 Audi A5 Quattro, and 2019 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Contamination damages the Mechatronic.
- A clean work environment is required for working on the Mechatronic.
The system is under pressure.
- Deactivate the ATF pump and drain the hydraulic pressure reservoir before removing the transmission fluid pan!
- Using the Vehicle Diagnostic Tester , empty the ATF pres- sure reservoir in the Transmission Control Module - J217- and disable the Transmission Fluid Auxiliary Hydraulic Pump - V552- . Refer to ATF PUMP, DEACTIVATING AND DRAINING THE HYDRAULIC PUMP RESERVOIR .
- Remove the Mechatronic. Refer to MECHATRONIC, REMOVING AND INSTALLING .
- Remove the Transmission Control Module -J217-. Refer to TRANSMISSION CONTROL MODULE -J217-, REMOVING AND INSTALLING .
Secure the Mechatronic on the vise as shown using the :T40321 .
Remove the bolts -arrows-.
Remove the ATF motor -1- with the ATF pump -2- downward at the same time pay attention that the ATF pump -2- does not fall down.