Transmission Control Module -J217-, Removing And Installing: Installing: Notes
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2020 Audi A4, 2019 Audi A5 Quattro, and 2019 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Before installing clean the control module threaded holes of oil and debris.
Push the control module evenly on the valve body and tighten the bolts in the sequence -1 to 4- to the tightening specification.
TIP:
CAUTION:
There is a risk of damaging the ATF pump.
- The sensor arm -1- must make contact when attaching the ATF pump -2-.
-
Tighten the bolts to the specification in the following sequence: -1 through 3-.
Install the cover -1- for the sensor arm -arrows-.
Install the Hydraulic Pressure Sensor 1 -G545- and Hydraulic Pressure Sensor 2 -G546-.
- Do not switch the connectors.
- Make sure that the connection is correct as shown -1 and 2-. Refer to Hydraulic Pressure Sensor 1 -G545- AND Hydraulic Pressure Sensor 2 -G546-, REMOVING AND INSTALLING .
- Install the Mechatronic. Refer to MECHATRONIC, REMOVING AND INSTALLING .
- If the Transmission Control Module - J217- was replaced, the function "control module replacing" must be performed using the - Vehicle Diagnostic Tester.
- If the valve body is replaced, the "valve body, replacing" function must be performed using the ? Vehicle diagnostic tester.
- Connect the Vehicle Diagnostic Tester with the vehicle.
- Network plan or control module list
- 02 - Transmission Electronics, Guided Functions
- 02 - Control Modules/Mechatronic, Replacing
- or
- 02 - Valve Body, Replacing
- Start the selected program and follow the instructions in the display of the Vehicle Diagnostic Tester.