Solenoid Valves And Pressure Regulating Valves In Valve Body, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2020 Audi A4, 2019 Audi A5 Quattro, and 2019 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

Coat the valve surface with ATF and push in the valves all the way.
Hold the Solenoid Valve 5 -N92- in direction of -arrow-.
Using the Precision Straight Edge (2 pc.) - T40100- align the connection evenly as shown.
Courtesy of AUDI OF AMERICA, LLC

Connect the contact element evenly.
Install the bolts in direction of -arrows- and tighten to the tightening specification.

Courtesy of AUDI OF AMERICA, LLC
Courtesy of AUDI OF AMERICA, LLC

Tighten the bolts -arrows- to the tightening specification.
Tightening Specification: OVERVIEW - VALVE BODY .
Install the Transmission Control Module -J217-. Refer to TRANSMISSION CONTROL MODULE -J217-, REMOVING AND INSTALLING .
Install the Mechatronic. Refer to MECHATRONIC, REMOVING AND INSTALLING .

After replacing the Solenoid Valves -- the function "Calibrating valves" must be performed using the Vehicle Diagnostic Tester.