Overview - MECHATRONIC: Notes
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2020 Audi A4, 2019 Audi A5 Quattro, and 2019 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
- Transmission Fluid Pan
- Removing and installing. Refer to TRANSMISSION FLUID PAN, REMOVING AND INSTALLING .
- Tightening specifications and sequence. Refer to 16
- Bolt
- M6 x 30
- Replace after removing.
- Tightening specification and sequence. Refer to Figure.
- Seal
- Replace after removing.
- Bolt
- Replace after removing.
- Tightening specification and sequence. Refer to Figure.
- Bracket
- Hydraulic Pressure Sensor 1 -G545- and Hydraulic Pressure Sensor 2 -G546-
- Removing and installing. Refer to HYDRAULIC PRESSURE SENSOR 1 -G545- AND HYDRAULIC PRESSURE SENSOR 2 -G546-, REMOVING AND INSTALLING .
- Seals
- Replace after removing.
- Contact Element
- Bolt
- 3 Nm + 90°
- Replacing
- M6 X 25
- O-ring
- Replace after removing.
- Bleed Pipe
- Dust Ring
- Seals
- Replace after removing.
- Seal
- Replace after removing.
- For vehicles with Parking Lock Solenoid -N486-
- Mechatronic
- Removing an installing. Refer to MECHATRONIC, REMOVING AND INSTALLING .
- Mechatronic Bolts
- Refer to Figure
- M6 X 90
- Bolt
- 3 Nm + 90°
- Replace after removing.
- For vehicles with Parking Lock Solenoid -N486-
- M6 X 22
- Seal
- Replace after removing.
- Refer to Overview - Seal
- Transmission Control Module -J217-
- Oil Pipe
- For vehicles with Parking Lock Solenoid -N486-
- Cable Guide
- Replace after removing.
- Seals
- Replace after removing.
- ATF Pipe
- Replace after removing.
- Seals
- Replace after removing.