Hydraulic Pressure Sensor 1 -G545- And Hydraulic Pressure Sensor 2 -G546-, Removing And Installing: Notes
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2020 Audi A4, 2019 Audi A5 Quattro, and 2019 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools and Workshop Equipment Required
NOTE:
- The Mechatronic remains installed.
WARNING:
The System Is Under Pressure.
- Deactivate the ATF pump and drain the hydraulic pressure reservoir before removal.
- Using the Vehicle Diagnostic Tester , empty the ATF pres- sure reservoir in the Transmission Control Module - J217- and disable the Transmission Fluid Auxiliary Hydraulic Pump - V552- . Refer toATF PUMP, DEACTIVATING AND DRAINING THE HYDRAULIC PUMP RESERVOIR .
- Remove the transmission fluid pan. Refer to TRANSMISSION FLUID PAN, REMOVING AND INSTALLING .
Release the catches -arrows- from the connector for the Hydraulic Pressure Sensor 1 -G545- -1- and Hydraulic Pressure Sensor 2 -G546- -2- and disconnect from the Transmission Control Module -J217-.
Disconnect the connector using the :T40305 .
-
Courtesy of AUDI OF AMERICA, LLC
Loosen the bolts in the sequence -7 to 1-.
- Remove the Hydraulic Pressure Sensor 1 -G545- -1- and Hydraulic Pressure Sensor 2 -G546- with the retaining plate -arrow A- and wiring guide -arrow B-.