LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> A4 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 1208 (Exhaust System, Emission Controls [CABB, CABA, CABD, CAEA, CAEB, CDHB, CDNB, CDNC, CDHA, CDZA, CADA, CCUA, CFKA, CPMA, CAED, CPMB] (Coupe)) >> 26 Exhaust System, Emission Controls >> Exhaust Pipes/Mufflers >> Front Exhaust Pipe, Removing And Installing >> Removing

Front Exhaust Pipe, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi A5 Quattro, 2016 Audi A5 Quattro, 2015 Audi A5 Quattro, 2014 Audi A5 Quattro, and 2013 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Nuts -Arrows-
GWWA26-11208Courtesy of AUDI OF AMERICA, LLC

-- Remove The Noise Insulation. Refer To NOISE INSULATION, REMOVING AND INSTALLING .

-- Remove the nuts -arrows-.

Fig 2: Clamping Sleeve Threaded Connections
GWWA26-10538Courtesy of AUDI OF AMERICA, LLC
CAUTION:

Risk Of Damaging The Coupling.

  • Coupling Must Not Be Bent More Than 10°.
  • Do Not Load The Coupling On The Cable.
  • Do Not Damage The Wire Mesh On The Coupling.

-- Loosen The Threaded Connections -Arrows-, Slide The Clamping Sleeve To The Rear And Remove The Front Exhaust Pipe/Front Muffler.

scientia non olet · About LEMON Manuals