Instrument Panel Vents And Rear Vents, Removing And Installing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The following illustrations show the location of the components on an Audi A5 Coupe; an Audi A5 Sportback, Audi A4, Audi Q5, etc. the location of the components varies slightly. Removing and installing the components is the same as described for the Audi A5 Coup e.

Instrument Panel Vents -B And C-, Removing And Installing. Refer To INSTRUMENT PANEL VENT, REMOVING AND INSTALLING .

Fig 1: Identifying Instrument Panel Vents, Removal And Installation

Courtesy of AUDI OF AMERICA, LLC

Remove the vent in the rear center console in the same way as removing the vents in the instrument panel. Refer to CENTER CONSOLE, REMOVING AND INSTALLING .

CAUTION:

So that instrument panel vent is not damaged when removing, the T-Handle Hook:3438 -A- must not be engaged on to fins of the vents -B and C-.

-- Turn Off The Ignition.

-- Open the affected vent.

-- Insert the T-Handle Hook:3438 -A- into the vent as illustrated.

-- Swivel the T-Handle Hook:3438 -A- approximately 90° toward the vent housing; insert the hook into the removal holes inside the vent housing.

-- Carefully remove instrument panel vent -B or C- from the instrument panel.