Right Flange Shaft Needle Bearing, Removing And Installing

Special tools and workshop equipment required

Procedure

-- Remove the right flange shaft. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .

-- Mount the : T10047 as illustrated.

The markings "B" on both parts face each other
The depressions -arrows- must be under the bearing.

Fig 1: Arranging Both Parts Of T10047 So That Marks "B" Face Each Other
Courtesy of AUDI OF AMERICA, LLC

-- Bolt the parts together.

-- Remove the locking ring -A-.

Fig 2: Identifying Tool Assembly To Pry Out Needle Bearing Circlip

Courtesy of AUDI OF AMERICA, LLC

-- The shaft must be rotated while pressing off in direction of -arrow- so that the contact surface on the needle bearing does not get damaged.

-- The shaft must be rotated while installing in direction of -arrow- so that the contact surface on the needle bearing does not get damaged.

Fig 3: Identifying Rotation Of Shaft To Install Circlip Using Special Tools

Courtesy of AUDI OF AMERICA, LLC

-- Secure the needle bearing with a new circlip.

-- Install the right flange shaft. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .