Overview - Front Three-Point Seat Belt, Market-Specific

Fig 1: Exploded View Of Front Three-Point Seat Belt, Market-Specific

Courtesy of AUDI OF AMERICA, LLC

1. Seat Belt Guide
   • Must swing into vertical position or carrier direction by itself after tightening the screw.
2. Bolt
   • 40 Nm
   • Replace the bolt if it was removed because of an accident when the seat belt was buckled.
3. Bolt
   • 40 Nm
   • Replace the bolt if it was removed because of an accident when the seat belt was buckled.
4. Automatic Belt Retractor
   • Driver Side: with Driver Seat Belt Tensioner Igniter 1 -N153-, Driver Belt Force Limiter -G551- and Left Front Seat Belt Tensioner Control Module -J854-
   • Passenger side: with Front Passenger Seat Belt Tensioner Igniter 1 -N154-, Front Passenger Belt Force Limiter -G552- and Right Front Seat Belt Tensioner Control Module -J855-
   • Removing and Installing. Refer to FRONT THREE-POINT SEAT BELT, REMOVING AND INSTALLING, MARKET-SPECIFIC .
   • After replacing the Left Front Seat Belt Tensioner Control Module -J854- / Right Front Seat Belt Tensioner Control Module -J855-, the control module must be coded using the Vehicle Diagnostic Tester.
5. Connector
   • Drivers side: for Driver Seat Belt Tensioner Igniter 1 -N153- and Driver Belt Force Limiter -G551-
   • Front passenger side for Front Passenger Seat Belt Tensioner Igniter 1 -N154- and Front Passenger Belt Force Limiter -G552-
6. Bolt
   • 4 Nm
7. Pop Rivet Nut
   • Riveted in the b-pillar.
8. Front Seat Belt Guide
   • Removing and Installing. Refer to FRONT SEAT BELT GUIDE, REMOVING AND INSTALLING .
   • Place seat belt webbing in the front seat belt guide
   • Do not jam or damage the seat belt webbing
9. Bolt
   • 40 Nm
   • Replace the bolt if it was removed because of an accident when the seat belt was buckled.
10. Seat Belt Guide
    • Must swing into vertical position or carrier direction by itself after tightening the screw.
11. Bolt
    • 27 Nm
    • Replace the bolt if it was removed because of an accident when the seat belt was buckled.
12. Seat Belt Height Adjuster
    • Removing and Installing. Refer to SEAT BELT HEIGHT ADJUSTER, REMOVING AND INSTALLING .
    • Seat belt height adjuster must be replaced if the belt tensioner has deployed with the belt buckled
13. Connector
    • Driver side: for Left Front Seat Belt Tensioner Control Module -J854-
    • For Right Front Seat Belt Tensioner Control Module -J855-
14. Driver Seat Belt Tensioner Igniter 2 -N297-
    • Passenger side: Front Passenger Seat Belt Tensioner Igniter 2 -N298-
    • Removing and Installing. Refer to FRONT BELT TENSIONER, REMOVING AND INSTALLING, MARKET-SPECIFIC .
15. Bolt
    • 20 Nm
    • Replace the bolt if it was removed because of an accident when the seat belt was buckled.
    • Quantity: 2
16. Belt End Fitting
    • Removing and Installing. Refer to FRONT BELT ANCHOR, REMOVING AND INSTALLING, MARKET-SPECIFIC .