Tightening Specifications For Bearing Bracket - For Steel Bolts
WARNING: This page is about a different variant/trim than selected.
- Replace the bolts that were tightened with an additional turn after removing them.
| Step |
Bolts |
Tightening Specification/Additional Turn |
| 1. |
-1 to 7- |
Install by hand all the way |
| 2. |
-1 to 6- |
9 Nm |
| 4. |
-7- |
Pre-Tighten to 8 Nm |
| 5. |
-7- |
90° additional turn |