Radiator, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal and note the following:

NOTE:

If there are small impressions on the slats. Refer to appropriate service information. .

Replace the O-rings.

-- Install the front bumper cover. Refer to FRONT BUMPER .

-- Install the fan shroud. Refer to FAN SHROUD, REMOVING AND INSTALLING .

-- Connect the coolant hose to the connector coupling. Refer to CONNECT THE COOLANT HOSE TO THE CONNECTOR COUPLING .

-- Install the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

NOTE:

Used coolant cannot be used again.

-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING .