Fan Shroud, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
-- Vehicles with right auxiliary radiator: remove the bolts -arrows- and push the coolant pipe toward the rear.
-- Remove the noise insulation. Refer to NOISE INSULATION .
-- Loosen the clamps -1 and 2- and remove the air duct hose.
WARNING:
There is a risk of injury if the radiator fan turns on by itself.
- Disconnect the connectors before working near the fan shroud.
-- Disconnect the connector -1- for the radiator fan, to do this push the clip in the direction of -arrow A- and push the retainer downward.
-- Push the left and right locking latches for the fan shroud at the same time in direction of -arrow B- and remove the fan shroud upward from the radiator and remove from underneath.