Coolant Thermostat Housing, Removing And Installing: Installing
Install in reverse order of removal and note the following:
- Replace the seals and O-rings.
-- Coat the O-rings -4- with coolant. Refer to Parts information for the coolant.
-- Make sure that both centering pins are installed in the cylinder block if necessary insert.
-- Install the connection piece -2- into the engine oil cooler -1-.
-- Push the coolant thermostat housing -3- onto the connection piece and onto the centering pins in the cylinder block.
-- Tighten the coolant thermostat housing bolts. Refer to THERMOSTAT - TIGHTENING SPECIFICATION AND TIGHTENING SEQUENCE .
-- Install the coolant pump. Refer to COOLANT PUMP/COOLANT THERMOSTAT .
-- Install the Throttle Valve Control Module -J338-. Refer to INTAKE MANIFOLD, REMOVING AND INSTALLING .
-- Secure the After-Run Coolant Pump -V51- again.
-- Connect the coolant hoses with the connector coupling. Refer to CONNECT THE COOLANT HOSE TO THE CONNECTOR COUPLING .
Used coolant cannot be used again.
-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING .
-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .