Fuel Level Sensor 2 -G169-, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
NOTE:
Replace the seal after removal.
Pull on the connectors to make sure they are securely connected and correctly locked.
-- Insert the Fuel Level Sensor 2 -G169- in the guides on the bracket and push down until it engages.
-- Install a new sealing flange seal -1-. It must be dry.
CAUTION:
Risk of leaking.
- When inserting the sealing flange, the seal must not be damaged or crushed.
-- Bring the sealing flange into its installation position.
- The tab -2- on the sealing flange must face the hole -arrow- in the locking ring and rest between the tabs -3 and 4- on the fuel tank.
-- Insert the locking ring and fasten using the :T10202 .
Further installation is performed in reverse order of removal, while noting the following:
-- Install the rear bench seat. Refer to BENCH SEAT/SINGLE SEAT, REMOVING AND INSTALLING .