SUBFRAME Mount, Checking Adjustment: Procedure
WARNING: This page is about a different variant/trim than selected.
The following dimensions must be attained:
- The clearance between the engine support -2- and the engine mount -1- must be -a- = 10 mm.
- The casting edge on the engine support must be parallel to the engine mount support arm.
- Dimension -b- = dimension -b-.
NOTE:
Distance -a- = 10 mm can also be checked with corresponding round stock.
-- If the distance measured is too small or too large, adjust the subframe. Refer to SUBFRAME MOUNT, ADJUSTING .