Engine, Supporting In Installation Position: Procedure
WARNING: This page is about a different variant/trim than selected.
-- Remove the plenum chamber cover -5-. Refer to BULKHEAD .
-- Remove the engine cover. Refer to ENGINE COVER .
-- Vehicles with a 1.8L engine: release the retainer in direction of -arrow- and remove the engine cover mount -1-.
-- Remove the caps over the front suspension strut threaded connections.
-- Position the :10-222A/31-1 and :10-222A/31-2 onto the mounts for the suspension struts.
- The ribs -arrow- face the direction of travel.
-- Position the :10-222A/4 with the :T40091/3 as shown.
-- Install the additional tools on the left in the engine compartment as shown.
-- Engage the carabiner hook of the :10-222A/11 at the left engine lifting eye -arrow-.
-- Slightly pretension the engine/transmission assembly with the spindle, do not lift.