Overview - Engine Oil Cooler
WARNING: This page is about a different variant/trim than selected.
- Sub-Assembly Bracket
- Removing and Installing. Refer to SUB-ASSEMBLY BRACKET, REMOVING AND INSTALLING .
- Seal
- Replace after removing
- O-Rings
- Replace after removing
- Coat with engine oil
- Mechanical Switch Valve
- Removing and Installing. Refer to MECHANICAL SWITCH VALVE, REMOVING AND INSTALLING .
- Engine Oil Cooler
- Removing and Installing. Refer to ENGINE OIL COOLER, REMOVING AND INSTALLING .
- O-Ring
- Replace after removing
- Quantity: 2
- Coat with coolant
- Connection
- Bolt
- 8 Nm +45°
- Replace after removing